Pego Electronics (Yi Chun) Company Limited
Pego Electronics-Focus on developing and promoting IEC lab testing equipments
Add to Cart
The IPX9K Ingress Protection Testing Machine, named as IPX9K High Pressure and Temperature Water Jetting Tester, is designed and manufactured according to IEC60529 clause 14.2.9 figure 7, 8, 9 and 10, GB4208, DIN40050-9 and ISO20653 standard. The main function of the ipx9k ingress protection testing machine is to test the performance of products during storage, transportation and use in a rainy climate environment. This equipment is mainly used for electronic and electrical products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their parts and components to test the physical and other related properties of products under climatic conditions simulating rain. After the test, the performance of the product is judged by verification to determine whether it meets the requirements, so as to facilitate the design, improvement, verification and factory inspection of the product.
IEC60529 Degrees of protection provided by enclosures (IP Code) Figure 3
ISO20653 Road Vehicles - Degrees of protection (IP-Code) - Protection of electrical equipment against foreign objects, water and access
DIN40050-9 Road Vehicles - Degrees of protection (IP-Code) - Protection of electrical equipment against foreign objects, water and access
| Model | IPX9K |
| Inner size | L1200*D1200*H1200mm (depends on the specimen) |
| External size | L1600*D1380*H2150mm |
| Test time | 30S for each position |
| Jet angle | 0°, 30°, 60°, 90° |
| Nozzle distance | 100-200mm (manual adjustable) |
| Numbers of jet | 4 |
| Diameter of turntable | 400mm |
| Lifting mode of turntable | Manual adjustable (adjust height: 420~660mm) |
| Spray distance | 100-200mm (manual control) |
| Water pressure | 8000-10000Kpa |
| Water flow | 14～16L / min |
| Water tank | 50L (recyclable) |
| Temperature | 250C (room temperature), 80±5℃ |
| Distribution impact force | 0.9~1.2N (water jet impact force calibration system) |
| Test time | 120s (30s/position) |
| Rotational speed of turntable | 1～10r/min(adjustable) |
| Bear weight of turntable | 50kg |
| Protection device | Leakage, water break, short circuit |
| Working Power(V) | 380V/50Hz (3 phase 4 wire + protective ground wire) |
| Sample Power (V) | 220V/50Hz |
| Power(KW) | 18 |
| Operation Language | English/Chinese Switchable |
| Safety protection function | Leakage protection, water shortage protection, short circuit protection, phase sequence protection, over-heat protection |
| Working condition | 5℃~35℃ (temperature), ≤85% (R.H.), 86kPa~106kPa (pressure) |
| Water source | 1). The user is required to configure a water source for the equipment at the installation site, with a water pressure not less than 0.2Mpa, and install a 4/8 inch faucet. 2). The faucet is not more than 2 meters away from the equipment |
| Requirement for the site | The ground is level, the drainage is unobstructed, the ground and walls are waterproofed, and the floor drain or drainage ditch is set |
| Requirement for power switch | 1). The user is required to configure the leakage protection air switch of the corresponding capacity for the equipment at the installation site, and this switch must be independent for the use of the equipment 2). It is forbidden to use knife switches or power sockets 3). The leakage protection air switch is not more than 2 meters away from the equipment |
